Get repair quotes

Free tool · TL-06

Cold room size and cooling load calculator

Put in the inside size, the temperature, the panels and the product you store, and see the floor area, volume, panel area and cooling capacity it needs.

A white walk-in cold room built against the back wall of a butchery, door half open on stainless shelving, with a condensing unit mounted outside above

Before you ask for cold room quotes, it helps to know roughly what you need. This calculator works out the floor area, volume and panel area of a walk-in chiller or freezer room, and estimates the cooling capacity from the heat through the panels, the warm air at the door and the product you bring in each day.

Cold room size and cooling load calculatorTL-06

Inside sizes. Outside, add twice the panel thickness.

Room
Panel thickness
Door use
Cooling capacity needed0 kW

    How the cooling load is worked out

    The calculator adds up the heat the refrigeration has to remove in a day, the same way a refrigeration engineer starts a load calculation:

    • Through the panels. Polyurethane panels conduct about 0.023 W per metre per kelvin, so a 100 mm panel lets through about 0.23 W per m² for each degree between outside and inside. The floor is taken at about 20 °C below the room.
    • Warm air at the door. Every time the door opens, warm, damp air comes in and has to be cooled and dried. Small rooms change their air more often for their size; a busy door doubles it.
    • The product. Food arriving warm has to be cooled to the room temperature, and in a freezer frozen as well, which takes far more energy than cooling.
    • The rest. Evaporator fans, lights, people and a safety margin of about 15%.

    The total is divided by the hours the unit runs (16 for a chiller and 18 for a freezer, leaving time for defrost) to give the capacity in kW. It is a first estimate to compare quotes against, not a design: a contractor should do the final selection.

    Typical sizes and loads

    Cooling loads from the same calculation for common walk-in sizes at 32 °C outside, from light use with a small daily product load to a busy door with a large one (meat arriving at 10 to 20 °C for a chiller, already frozen for a freezer room). Ready-built walk-in cold rooms of about 2.4 × 2.4 m with refrigeration sell for about R47,000 to R55,000 and freezer rooms for about R54,000 to R87,000 (supply only, published South African prices, November 2026).

    RoomFloorVolumePanelsCooling capacity
    2 × 2 × 2.2 m chiller4.0 m²8.8 m³75 mmabout 0.6 to 1.3 kW
    2.4 × 2.4 × 2.4 m chiller5.8 m²13.8 m³100 mmabout 0.7 to 1.6 kW
    3 × 3 × 2.4 m chiller9.0 m²21.6 m³100 mmabout 0.9 to 2.0 kW
    2.4 × 2.4 × 2.4 m freezer room5.8 m²13.8 m³100 mmabout 0.9 to 2.0 kW
    4 × 3 × 2.6 m freezer room12.0 m²31.2 m³125 mmabout 1.4 to 3.0 kW

    Panel thickness and temperature

    Room temperatureUsual panelFloor
    Chiller, 0 to +5 °C75 to 100 mmOften uninsulated concrete, or an insulated floor
    Freezer, -18 °C100 to 125 mmInsulated floor, heated door frame
    Low temperature, -25 °C and below125 to 150 mmInsulated floor with heating against frost heave

    See cold room panels, condensing units and cold rooms for prices and suppliers.

    Frequently asked questions

    What size refrigeration unit do I need for a cold room?
    For a 2.4 × 2.4 m chiller at 2 °C in South African summer heat, typically about 2 to 3 kW of cooling. A freezer room of the same size needs about the same or more, at a much lower temperature, so a bigger unit. The calculator gives an estimate for your room and use.
    How thick should cold room panels be?
    Usually 75 to 100 mm for a chiller and 100 to 125 mm for a freezer room at -18 °C, and 125 to 150 mm for lower temperatures. Thicker panels cost more but cut the running cost and the size of the unit you need.
    Why is horsepower not enough to compare cold room units?
    A unit's cooling capacity drops as the room gets colder and the outside gets hotter, and the same horsepower gives very different capacities with different gases and compressors. Ask for the capacity in kW at your room temperature and your outside temperature.
    How much does a cold room cost?
    Published South African prices put a 2.4 × 2.4 m walk-in chiller with refrigeration at about R47,000 to R55,000 and 3 × 3 m at about R52,000 to R63,000, supply only. Freezer rooms cost more. See cold rooms.

    More free tools

    Free quote request

    Request fridge repair quotes

    Fill in the job card the way a technician would on a call-out: what it is, what it's doing wrong, and how to reach you. Repairers, refrigeration technicians, cold room builders and spares suppliers who work in your area quote you directly.

    Service job cardFREE · NO OBLIGATION · CR-04 · SET POINT -2 °C
    JOB 031020

    01The job

    02Measure up (optional, it helps the quote)

    MEASURE-UP · COLD ROOM

    Appliance
    -
    Likely area
    -
    Units
    -
    Estimate
    -

    A rule of thumb from published prices, not a quote.

    03When

    04Request list (optional)

    1. 01
    2. 02
    Up to 12 lines: appliances, parts, cylinders or items.
    Needs and options

    05Your details

    Free and no obligation. By sending you agree that we may share your request with suitable technicians and suppliers. See our privacy policy.

    Get free fridge repair quotes